160.566UK User Manual
Placement:
The SW-3LED has a built-in snow fluid container and should always be operated in an upright position. If free-standing
please ensure that the unit is positioned on a stable, non-slip surface. If mounted at height, use the integral mounting
bracket and attach a safety cable for added security.
Safety:
•
Check for correct mains voltage and condition of IEC lead before connecting to power outlet.
•
Check the condition of the remote lead and ensure that it is not trapped.
•
This unit must be earthed.
•
This unit produces a snow effect using foam, which may cause a slip hazard on some floor surfaces.
Cleaning:
•
Use a soft dry or slightly damp to clean the casing.
•
Do not use strong solvents for cleaning the unit.
•
Clean the foam mechanism periodically by operating with distilled water instead of snow fluid.
Rear Panel:
Setting up:
The SW-3LED requires snow fluid, which forms small foam drops to create the snow effect.
It is recommended to use QTX snow fluid for best results (160.578, 160.579).
•
Unscrew the top cap of the fluid tank (removable) and fill with the selected snow fluid.
•
Replace the cap and close securely, ensuring the pipe is fed down to the bottom of the bottle so that a consistent
flow of fluid is supplied to the machine.
•
Connect the wired remote control to the connector on the rear panel (2).
•
Connect the IEC mains lead supplied to the rear mains inlet (3).
Remote control operation:
The SW-3LED comes supplied with both a wired and RF wireless remote control. The wired control is used for snow
control and has only a red square button in the centre and 2 green LEDs at the top. After switching on the unit using the
power button (1) wait for the 2 LEDs to light up before beginning the snow effect. Press the red square button once to
release the snow, press again to stop. For operation using the RF remote control please see below.
1.
Power on/off rocker switch
2.
Remote control connection
3.
Mains inlet (IEC male) and fuse holder
4.
Fluid level indicator
