Troubleshooting
“POWER” LED does not light on receiver
Ensure power adapter is connected to mains and working properly
Ensure receiver is switched on
“POWER” LED is lit but no “SIGNAL” LED
Ensure transmitter is switched on
Check that transmitter is not out of reception range
Check that transmitter battery is good / charged
LEDs are lit but no sound from microphone
Check if transmitter switch is in “MUTE” position
Check if neckband or lavalier microphone is connected to beltpack
Make sure receiver is connected to mixer / amplifier
Make sure that amplifier / mixer channel volume is turned up
Ensure transmitter has a good / charged battery
Check if there is another nearby transmitter with the same frequency
Microphone output is very loud or distorted
Turn down GAIN ADJUST on beltpack transmitter
Turn down VOLUME on receiver
Reduce Gain on mixer / amplifier
Ensure that XLR output is not fed to a Line input
Microphone output is very low
Turn up GAIN ADJUST on beltpack transmitter
Turn up VOLUME on receiver
Increase Gain on mixer / amplifier
Ensure that Jack output is not fed to a Mic input
Check transmitter battery
Note: for further troubleshooting, refer equipment to qualified service personnel for testing
© QTX Sound 2011
