6. Overlap
Controls the amount of overlap between successive grains as well as the size of individual grains.
Ranges from 1% to 600% of grain rate.
When the Secondary Freeze control is enabled, and the density control is all the way down, overlap will control the
grain size across a fixed range from 500us to 2 seconds.
CV input responds to +/- 5V, and is added to the knob position.
7. Blend
File Source
When the knob is fully counter-clockwise only the phase vocoded loop will output.
When the knob is fully clockwise only the granular loop will output.
Live Source
When Source is illuminated this controls the blend of the phase vocoder, granular stream, and dry input signal.
When the knob is set to the middle, only the dry signal will output.
When the knob is set fully counter-clockwise, only the phase vocoded loop will output.
When the knob is set fully clockwise, only the granular loop will output.
CV input responds to +/- 5V, and is added to the knob position.
8. Window
Changes the window shape of the grains being generated.
This control blends through each of the following hammer shapes in this order.
1. Gaussian .
2. Blackman-Harris .
3. Down.
4. Bartlett .
5. Up.
6. Hamming.
7. Square.
CV input responds to +/- 5V, and is added to the knob position.
11
Summary of Contents for Nebulae
Page 1: ...Nebulae 1...
Page 8: ...Marked Diagram 8...
Page 23: ...Secondary Controls No Secondary Controls have been implemented yet 23...
Page 31: ...Release Notes 31...
