© 2017 QuadH2O All Rights Reserved
SARAH2O PRO User Manual
12
Installing dome
The SARAH2O PRO has a perspex dome that is fitted to the front of the aircraft and is kept in place via
eight quick release, quarter turn clips. A complimentary micro fiber cleaning cloth and protective bag is
also provided.
A neoprene foam seal seated around the opening keeps the dome watertight.
To fit the dome, follow the instructions below:
1. Move all of the clips to their open position
2. Using the supplied silicone grease, apply a thin later of grease over the dome neoprene seal
3. Place the dome onto the neoprene seal, ensuring it is seated evenly over the seal
4. Close the clips at apposing corners, e.g. bottom left, top right etc. Until all eight clips are in the
closed position
5. To remove the dome simply reverse the process
If you scratch the dome it is possible to remove marks by polishing them out using automotive/
car polish.
Place the aircraft upside down (on its back) to aid installing the dome.
Do not over tighten the clips.
You need to carry out a water test and adjust the clips on the dome before you fly over water.
Please refer to page 13 for instructions.
