Quadivator HyperCut RD62, Assembly/Operators/Parts Manual

Looping the chain around your frame should be done in a secure place to the frame of the ATV, 
there should be a connection point that is a minimum of 12” inward from the “tower” and as 
much as possible, the connection point - should be in-line with the tower on the other side.  Use 
the provided D-Pins to lock the chain in place to the tower, the other side of the tower is bolted 
to the chain! 
 

NOTE

 - When installed - the tether chains are secure, but they will remove 

some

 paint from 

your ATV at the attaching point when the deck operates and moves underneath you ATV as you 
are mowing.  

If this minor paint removal is not satisfactory because of its visibility - 

then find a non-visible and SECURE location in another location on the ATV!   

Step 10

 – 

Trim the excess and unneeded chain

 from both sides of the chain towers! 

IMPORTANT – DO NOT OPERATE MOWER

 until all excess chain is trimmed from the 

connection to the mower towers to the ATV – cut the chain to the minimum length required to 
operate the mower.  Failure to trim/cut chain to minimum length may cause damage to rotating 
drives, cutting blades, the operator and/or bystanders. 
 

Step 11

 – Operate the ATV/Mower Unit around in the area at speeds not over 5 mph (or 8 kph) 

to ensure that the connections are secure and nothing has moved or shifted in the attaching 
points.  Operate the unit SLOWLY - in reverse - turn right and left and then recheck for 
movement from right to left when operating forward at 5 mph. 

3.4 Removing and Re-attaching the Mower  

When disconnecting the HyperCut Mower from your ATV, take the following Steps: 

NEVER disconnect the ATV from the HyperCut Mower 
with the mower engine running – ALWAYS shut the 
mower engine off before disconnecting from the ATV.  

WARNING 

Step 1

 - 

Stop the ATV

 where you want to leave the mower and 

SHUT OFF

 the ATV and place 

in PARK and apply the handbrake. 
 

Step 2 

- 

Disconnect the chains

 from both sides of the ATV - which connect the mower deck 

to the ATV by removing the D-pins, and lay the towers down flat, with the chain away from the 
deck. 

 
Step 3

 - 

BLOCK 

the rear pneumatic wheels of the mower – both forward and rear sides of the 

pneumatic wheels! 
 

Step 4

 - Remove the retaining pin from the rear hitch and lift the swivel hitch from the hitch pin 

on the ATV up and rearwards – in a resting position. 
 

Step 5

 - Grasp the mower by the nerf bar and ensure it is completely free from the ATV. 

 
Step 6

 – Re-start your ATV and - with the brake “covered” - proceed forward 

SLOWLY and 

WITH CAUTION

 - 

driving over the deck and clearing the mower entirely and leaving it 

in place until next “mowing” time. 
 
Step 7

 – In order to attach the ATV to the HyperCut Mower, reverse Steps 6 – 1.