Vendetta Quick Start Guide
** If the Vendetta just beeps when arming**
We have found that sometimes if the Vendetta is powered on and con
fi
gured in Clean
fl
ight
before the OSD calibration has been completed, such as when
fl
ying line of sight, that the
Vendetta will not arm. This is because the On Screen display is set to mandatory calibration
and this menu must be exited before the Vendetta can be armed and
fl
own. in this case,
follow the instructions below:
Existing setup (if you have already configured cleanflight)
If you already have everything set up on your POWERCUBE and you are just adding the
CORE PRO, select “READ CLEANFLIGHT RC DATA” in the CORE PRO menu and the CORE
PRO will apply the settings from your Clean
fl
ight setup.
The same process will be run if you choose to SKIP a mandatory calibration procedure.
After these steps you will be able to control the OSD with your Roll- and Pitch-stick.
Page of
4
5
©2016 QuadQuestions LLC.
Calibrating flight modes is not required. You can
ROLL RIGHT to skip, or assign a free 3-pos
switch in your R/C to take advantage of this
feature. Keep in mind that the default flight mode
for Cleanflight is ACRO.
