6
09/20
7074-803C
C. Tools And Supplies Needed
B. Thermostat Wall Control Location
The thermostat wall control’s location will have some affect
on the appliance’s operation.
• Maximum wire length from appliance is 100 feet
(30.48m) continuous non-spliced wire. Recommended
20 gauge wire, solid copper
.
• When located close to the appliance, it may require a
slightly higher temperature setting to keep the rest of
the house comfortable.
•
When located in an adjacent room or on a different
floor level, you will notice higher temperatures near
the appliance.
D. Inspect Appliance and Components
•
Open the appliance and remove all the parts and
articles packed inside the Component Pack. Inspect all
the parts and glass for shipping damage.
• Report to your dealer any parts damaged in shipment.
• All labels have been removed from the glass door.
• Plated surfaces have been wiped clean with a soft
cloth, if applicable.
•
Read all the instructions before starting the
installation. Follow these instructions carefully
during the installation to ensure maximum safety
and benefit.
• Follow pipe manufacturer instructions for
installation and air clearance requirements.
Risk of Fire!
• Damaged parts could impair
safe operation.
•
Do NOT install damaged, incomplete or
substitute components.
WARNING
WARNING
Hearth & Home Technologies disclaims any
responsibility for, and the warranty will be
voided by, the following actions:
• Installation and use of any damaged appliance.
•
Modification of the appliance.
• Installation other than as instructed by Hearth &
Home Technologies.
• Installation and/or use of any component part not
approved by Hearth & Home Technologies.
•
Operating appliance without fully assembling
all components.
•
Operating appliance without legs attached (if supplied
with appliance).
•
Do NOT Over fire!
Or any such action that may cause a fire hazard.
Tools and building supplies normally required for
installation, unless installing into an existing masonry
fireplace:
- Reciprocating Saw
- Channel Locks
- Hammer
- Phillips Screwdriver
- Tape Measure
- Plumb Line
- 1/4” Self-Tapping Screws
- Framing Material
- Hi-temp Caulking Material
- Gloves
- Safety Glasses
- Framing Square
- Electric Drill & Bits (1/4”)
- Level
May also need:
- Vent Support Straps
- Venting Paint
