23
08/22
7021-801F
F. Optional Log Set Placement Instructions
2 Piece Log Set Installation
1. Open door to expose the firebox.
2. Install the left log first and then the right log
(Figure 23.4)
.
3. Lean the logs against the cast iron brick in the back of the
firebox.
4. Push the logs to the far left and far right against the sides
of the firebox
(Figure 23.5)
.
5. To clean the logs, use a vacuum and a soft brush
attachment or a paint brush.
Figure 23.4
Figure 23.5
NOTE:
Due to the abrasive nature of a pellet appliance fire,
the logs are not covered under warranty. Any placement
variation other than shown here can cause excessive heat
and shall void the appliance warranty.
E. Leg Leveling System
1. Thread Allen bolts through nuts until flush
(Figure 23.1)
.
The Allen bolts and nuts are included in the component
pack inside the appliance firebox.
2. Slide assembled nuts and bolts into slots on legs with
the nuts on the bottom
(Figure 23.2)
. Use a 5/32 in.
(3.96mm) Allen wrench to adjust legs up and down to
desired level
(Figure 23.3)
.
Figure 23.3
- Bolt fully extended
Figure 23.1
Figure 23.2
Logs are FRAGILE. Use extreme care when handling or
cleaning logs.
CAUTION
