Page 18
7021-130F
May 12, 2014
Castile-B FS Pellet Stove
7
Appliance Set-Up
A. Outside Air Kit Instructions
Parts Included in Kit:
1 piece of 2 inch x 3 foot fl ex hose, 2 hose
clamps, 1 collar assembly,1 termination cap assembly, 1 trim ring,
12 screws.
1. Measure distance from fl oor to air vent opening in appliance
and mark location on wall.
Use saw to cut opening in wall. Cut a 2-1/2 to 3 inch
(64-76mm) opening on inside wall and a 3 to 3-1/2 inch
(76-89mm) opening on outside of house.
2. Use hose clamp to secure fl ex pipe to collar assembly.
3. Slide trim ring over fl ex pipe and run pipe through wall.
4. Attach hose to outside termination cap with second hose
clamp.
5. Secure termination cap to outside surface.
6. Secure trim ring to interior wa
ll.
Tools Needed:
Phillips headscrewdriver; wire cutters; hole saw or
jig saw.
CAUTION
Never draw outside combustion air from:
• Wall,
fl oor or ceiling cavity
• Enclosed space such as an attic or garage
Mounting Slots
Pre-cut Hole
Align hooks with slots, push up
and slide forward
1.
Figure 18.1
shows bottom of convection blower mount and pre-
cut air vent opening for reference only. Air channel should be
mounted with stove in upright position.
2.
Align hooks in air channel with slots in convection blower mount
and ash box,
Figure 18.2
. Push up and slide forward.
3. Secure air channel to appliance with 2 screws and secure the
collar assembly to the air channel with 2 screws.
Figure 18.3.
Figure 18.1
Attach air channel to stove with 2 screws
Attach collar to air channel with 2 screws
Figure 18.2
Figure 18.3
Figure 18.4
Flex Hose
Hose Clamp
Collar Assembly
Trim Ring
Termination
Cap Assembly
Hose Clamp
Air Intake
Channel
