20
April 23, 2019
7021-801B
CASTILE FREESTANDING
6
Appliance Set-Up
A. Outside Air Kit Instructions
Flex Hose
Hose Clamp
Collar Assembly
Trim Ring
Termination
Cap Assembly
Hose Clamp
Air Intake Channel
(Discard)
Figure 20.2
Figure 20.1
Mounting Slots
Pre-cut Hole
Align hooks with slots, push up
and slide forward
Attach air channel to stove with 2 screws
Attach collar to air channel with 2 screws
Figure 20.3
Figure 20.4
1. Figure 20.1
shows bottom of convection blower mount
and pre-cut air vent opening for reference only. Air
channel should be mounted with appliance in upright
position.
2. Align hooks in air channel with slots in convection
blower mount and ash box
(Figure 20.2)
. Push up and
slide forward.
CAUTION
Never draw outside combustion air from:
•
Wall, floor or ceiling cavity
• Enclosed space such as an attic or garage
3. Secure air channel to appliance with 2 screws and
secure the collar assembly to the air channel with 2
screws
(Figure 20.3)
.
4.
Measure distance from floor to air vent opening in
appliance and mark location on wall. Use saw to
cut opening in wall. Cut a 2-1/2 to 3 inch (64-76mm)
opening on inside wall and a 3 to 3-1/2 inch (76-89mm)
opening on outside of house.
5. Use hose clamp to secure flex pipe to collar assembly.
6. Slide trim ring over flex pipe and run pipe through wall.
7. Attach hose to outside termination cap with second
hose clamp.
8. Secure termination cap to outside surface.
9. Secure trim ring to interior wall.
