May 12, 2014
7022-122D
Page 39
Castile Pellet Insert
Brick is flush against back wall
Notches
exposed
Re-installing Baffl e & Brick Set
1. Place right brick in behind the right bracket, and then
slide to the left so the tabs are behind the center brick.
Figure 39.4.
2. The brick will be fl ush against the back wall and notches
exposed in the side bracket.
Figure 39.5.
3. Lift slightly and pull the right edge of the brick forward until
it stops and then drops down into both top and bottom
notches of right bracket and locks into place.
Figures
39.1 and 39.2.
4. Repeat for left brick.
5. Insert baffl e into top front inside the fi rebox and pull for-
ward. Then raise up the bottom end and insert baffl e tab
into slot on the top of the right bracket to lock into place.
Figure 39.3.
Place the left side hook at the bottom of the
baffl e over the top edge of brick for stability.
Figure 37.4.
6. The baffl e does not completely cover the top of the fi rebox.
There is an opening on the left as shown in
Figure 40.5 on
page 40.
NOTE: Improper installlation can cause poor appli-
ance performance.
Tabs
Figure 39.4
Figure 39.5
I. Baffl e & Brick Set Removal
1. Follow proper shutdown procedures in Section 10.
2. The top baffl e has a hook on the bottom left side that
rests on the top lip of the cast brick. There is a tab on
the bottom right side that hooks into the side bracket.
Remove the top baffl e by fi rst pulling the baffl e forward
until back edge drops down. Then slide baffl e back and
down until the front edge clears the shelf that it had been
resting on.
Figure 39.1.
3. The top baffl e must be removed before you can remove
the right and left brick. Remove the right brick by hold-
ing top lip of brick and lifting up, then push outside edge
back. Slide brick to the right until it is fl ush with the fi rebox.
Rotate the inside edge of the brick forward and remove
brick. Repeat for left brick.
Figure 39.2.
Remove Right
& Left Brick
Vacuum
Exhaust Area
Right Brick
Removed
Drop Tube
Figure 39.1
Figure 39.2
Figure 39.3
