22
7022-514C
July 7, 2015
CASTILE INSERT
Panel Extension
Panel Leg
Cast Trim Footer
Figure 22.1
F. Hearth Support (Cont’d)
Base Plate Only Installation
Parts Needed
: (1) cast ring (2) base zero clearance panel
extensions. Discard balance of parts.
Tools Needed:
Phillips head screwdriver
1. Attach base zero clearance panel extensions to cast
ring.
2. Place assembly under appliance.
G. Surround & Trim Set, Econo
Included in Surround Kit:
2 side pieces, left and right, top
piece and fastener package.
Included in Basic Trim Kit:
2 side pieces, left and right, top piece
and “L” brackets.
Tools Needed:
4-6 inch long Philips head screwdriver,
pliers and fl at head screwdriver
1. Lay surround face down on a fl at protected surface to
prevent scratching.
2. Using the Philips head screwdriver attach the side
surrounds to the top surround using 2 sheet metal screws
provided with the kit on each side.
3. Assemble the trim with the two corner brackets provided.
4. Slide the assembled trim over the assembled surround
set.
5. Remove the cast sides before attaching the surround
and trim. Lift up the top to expose the thumb screws that
secure the cast sides. Remove the thumb screw and top
bracket and then remove the cast side. NOTE: The right
cast side bracket has the hopper cut out switch attached.
Remove the retainer from the right side and allow to
hang down into the insert or disconnect the switch when
removing side.
6. Install the power cord in the surround.
7. If power enters the appliance on the right side: Using
the pliers, attach cord restraint 12 inches from the female
end of the cord and then press into the right side panel.
Figure 22.2.
8. If power enters appliance on the left side: The cord will
have to be routed through the back of the insert. When
routing the power cord, keep cord lying fl at as possible,
keeping the cord away from all exhaust surfaces and
moving parts. After routing, install cord restraint and
press into the left side panel.
9. Slide surround over the top of the insert into
place.
Surround attaches to bottom and top of insert sides with
the supplies 1/4 inch screws.
10. Plug cord into inlet on junction box routing the wire.
11. Install plug into unused hole.
Back of Top Panel
Back of Side Panel
Screws
Figure 22.3
Figure 22.2
Figure 22.5
Thumb
Screw
Bracke
Surround Set
attaches to top
and bottom of
insert sides.
Figure 22.4
