22
June 4, 2019
7027-801C
CB1200 Free Standing
Power Outlet
Terminal Block.
Center 2 screws for
Thermostat Wires
Figure 22.1
There is a 4 screw terminal block located on the back
lower left corner of the stove directly above the power
cord inlet. The center 2 screws are for the thermostat
wires (
Figure 22.4
).
Figure 22.2
Figure 22.3
Figure 22.4
1. Separate the body of the thermostat from the
mounting plate by gently pulling the two pieces
apart
(Figure 22.1)
.
2. Use a drill with either a 3/16 drill bit for drywall or a 7/32
drill bit for plaster drill holes.
3. Using a hammer tap in wall anchors.
4. Route the wires through the opening in the base plate,
and hold the base against the wall while aligning up
to the holes. Attach base plate using a Phillips head
screwdriver and two screws.
5. Connect your thermostat wire to the W and R
terminals
(Figure 22.2)
.
W
R
W
R
Appliance
BATTERY
BATTERY
NOTE:
Ensure bare wire ends are held ALL the way
into the terminal block while the screws are
being tightened.
6. There are two
AA ALKALINE ONLY
batteries
already installed into the thermostat; to activate,
remove black plastic tab that is located inside the
battery compartment.
7. Snap the thermostat to the base plate.
Shock hazard.
•
Do NOT remove grounding prong
from plug.
• Plug directly into properly grounded 3
prong receptacle.
• Route cord away from appliance.
•
Do NOT route cord under or in front
of appliance.
CAUTION
