23
June 4, 2019
7027-801C
CB1200 Free Standing
E. Optional Log Set Placement Instructions
1.
Place the front log in first as shown in
Figure 23.1
.
Place log between fire pot and face of appliance with
charred area surrounding fire pot.
2. Set the left and right logs onto the front log, placing
the holes in the base of the left and right logs over the
locating pins in front log (See
Figure 23.2).
Ensure that
the charred ends are facing the fire pot.
Figure 23.1
NOTE:
Due to the abrasive nature of a pellet appliance
fire, the logs are not covered under warranty.
Any placement variation other than shown here
can cause excessive heat and shall void the
appliance warranty.
LOCATING PINS
Charred Areas in the Back
Top Log
Right
Top Log, Left
Front Log
Figure 23.2
Install Logo
F. Installing Logo
1. Remove logo from packaging.
2. The logo has 2 studs on the back.
3. Install the logo on the lower left side of the center
panel by pressing the 2 studs into the already drilled
holes (
See Figure 23.4).
Figure 23.3
CAUTION
Logs are FRAGILE. Use extreme care when handling or
cleaning logs.
