R
R
R
April 9, 2009
7051-158
Page 9
EDGE 60 Pellet Fireplace
Changing to Different Fuel Type
•
Empty the hopper of the previous fuel
•
Thoroughly vacuum hopper before filling with the new
fuel
•
Select the appropriate setting on the FUEL SELECTION
screen on the thermostat wall control
The burn rate, BTU content and heat output will all vary
depending on the fuel selected.
Storage
• Wood pellets should be left in their original sealed bag
until using to prevent moisture absorption.
• Shelled corn, wheat or sunflower seeds should be stored
in a tight container to prevent it from absorbing moisture
from damp or wet floors.
• This will also prevent rodents from becoming a problem
.
• Do not store any pellet fuel within the clearance
requirements or in an area that would hinder routine
cleaning and maintenance.
D. General Operating Information
1. Thermostat Wall Control - Automatic Setting
The appliance is like most modern furnaces; when the
thermostat wall control calls for heat, your appliance
will
automatically light and deliver heat.
When the room is up to temperature and the wall control is
satisfied the appliance will shut down.
In the automatic setting the heat output level is controlled by
the wall control. Select “Automatic” on the AUTO/MANUAL
screen.
Figure 9.1.
2. Thermostat Wall Control - Manual Setting
When you select “Manual” on the AUTO/MANUAL screen the
appliance will still automatically turn on and off according to
the temperature setting.
However, you will be able to manually control the heat output
levels. Adjust the heat output levels by using the HEAT
OUTPUT LEVEL screen.
Figure 9.2.
Automatic
Manual
Off
Medium
3. Auto-Clean Firepot System
Your appliance is equipped with an automatic firepot cleaning
system that will change the frequency of cleaning based on
the fuel being burned.
The auto-clean system will clean itself immediately on initial
plug in. If there is a power outage, as soon as power is
restored it will recycle and clean itself if there is no fire in
the firepot.
F. Before Your First Fire
•
First, make sure your appliance has been properly installed
and that all safety requirements have been met
.
•
Pay particular attention to the fire protection, venting and
thermostat wall control installation instructions
.
• Double check that the ash pan, hopper and firebox are
empty and then close the firebox door.
NOTICE:
The tip of thermocouple must be in contact with the
inside end of the thermocouple cover or missed ignitions can
occur.
CAUTION!
Tested and approved for wood pellets, shelled
field corn, wheat and black oil sunflower seeds. Burning of
any other type of fuel voids your warranty.
Figure 9.1
Figure 9.2
Read and understand the Thermostat
Wall Control manual for detailed operating
instructions. The wall control is an intregal
part of how to operate this appliance.
E. Power Switch
The power switch is located at the bottom right hand corner of
the fireplace. It turns the power on and off to the fireplace.
Before servicing the fireplace this power switch must be in
the off position. When the power switch is OFF there will be
no display on the wall control screen.
Power Switch
I
0
= ON
= OFF
Power
Switch
Figure 9.3
