Hearth & Home Technologies Inc.
1445 North Hwy., Colville, WA 99114-2008
GarnetE SERIES ELECTRIC FIREPLACE
7
10/03
4035-823 Rev C
F. OPERATING INSTRUCTIONS
The operating controls are located on the back of the appliance.
1. Main Power Switch
a.
When the main power switch is turned on, it provides power to all functions.
b.
When used in conjunction with RC-ELEC-QUAD remote control the switch should remain in the ON position.
2. Intensity Switch
Controls the intensity of the ember bed and flame.
3. Heater Switch
a.
The heater switch provides power to the heater system.
b.
The RC-ELEC-QUAD remote control does not control this function.
4. Thermostat
a.
The thermostat allows you to adjust to the desired room temperature.
b.
To adjust the thermostat, turn the control knob clockwise all the way, then turn the knob counterclockwise until you hear a
click.
c.
To increase the desired temperature, turn the knob clockwise.
d.
To decrease the desired temperature, turn the knob counterclockwise.
G. MAINTENANCE INSTRUCTIONS
1. Cleaning the Firebox and Control Compartment
a.
Turn the stove off and disconnect the power cord from
the outlet.
b.
Allow the appliance to cool before cleaning.
c.
Remove the top of the stove by grasping the top on both
sides and lifting up.
d.
Remove the heater system. See Figure 5. Rest it on top
of the appliance so it does not fall.
e.
Remove the firebox top to access the log area.
f.
Replace all parts after cleaning has been completed.
g.
Plug in the power cord.
WARNING!
Always disconnect power and allow the appliance to cool before performing any cleaning, maintenance or relocation of
this appliance. Turn controls to OFF and remove the plug from the outlet or turn off the circuit breaker to the appliance.
Figure 5 - Remove the Heater System
