Page 13
March 2000
GB 40 I - FIREPLACE INSERT
After left and right brick panels are installed, bend brick
retainer tabs down (as shown below) to insure panels do
not move from their correct locations.
BRICK RETAINER TAB
INST
ALLA
TION:
BRICK
BRICK INSTALLATION
CAUTION: Brick is extremely fragile, handle with care.
The brick in this unit is packed within the firebox to prevent breakage during shipping. To install the brick,
follow the directions below:
1.
Place brick A on the lower bottom left side of the firebox at an angle, and tip the top edge up until it slides
into the slots on the top of the firebox and behind the manifold block. Bend brick retainer tab down.
2.
Place brick B on the lower bottom right side of the firebox at an angle, and tip the top edge up until it slides
into the slots on the top of the firebox. Bend brick retainer tab down.
3.
Place brick C on the left side of the firebox floor in front of the manifold block.
4.
Place brick D on the right side of the firebox floor so that the cutout slides around the log holder.
5.
Slide brick E in front of the front burner tube so that the brick fits between the burner tube and the face
of the insert. Brick must be moved toward face of insert, and MUST NOT BLOCK front burner tube air
shutter.
