October 28, 2014
7080-131D
5
MT VERNON E2
• Installation and use of any damaged
appliance.
• Modifi cation of the appliance.
• Installation other than as instructed by Hearth & Home
Technologies.
• Installation and/or use of any component part not
approved by Hearth & Home Technologies.
• Operating appliance without fully assembling all
components.
• Operating appliance without legs attached (if supplied
with unit).
• Do NOT Overfi re
Or any such action that may cause a fi re hazard.
WARNING
Hearth & Home Technologies disclaims any
responsibility for, and the warranty will be
voided by, the following actions:
Reciprocating Saw
Channel Locks
Hammer
Phillips
Screwdriver
Tape Measure
Plumb Line
1/4” Self-Tapping Screws
Framing Material
Hi-temp Caulking Material
Gloves
Safety Glasses
Framing Square
Electric Drill & Bits (1/4”)
Level
May also need:
Vent Support Straps
Venting Paint
Tools and building supplies normally required
for installation, unless installing into an existing
masonry fi replace:
C. Tools And Supplies Needed
B. Remote Thermostat Location
The remote thermostat’s location will have some affect on the
appliance’s operation.
•
When located close to the appliance, it may require a
slightly higher temperature setting to keep the rest of the
house comfortable.
•
When located in an adjacent room or on a different fl oor
level, you will notice higher temperatures near the appli-
ance.
CAUTION! The remote thermostat is an integral part of the
appliance. No other wall control or thermostat can be
substituted.
D. Inspect Appliance and Components
•
Open the appliance and remove all the parts and articles
packed inside the Component Pack. Inspect all the parts
and glass for shipping damage.
• Report to your dealer any parts damaged in shipment.
•
All labels have been removed from the glass door.
• Plated surfaces have been wiped clean with a soft cloth,
if applicable.
•
Read all the instructions before starting the installation.
Follow these instructions carefully during the
installation to ensure maximum safety and benefi t.
•
Follow pipe manufacturer instructions for installation
and air clearance requirements.
**HHT recommends a range limit of 20 feet for best perfor-
mance
MODE/SET
Risk of Fire!
Damaged parts could impair safe operation.
Do NOT install damaged, incomplete or
substitute components.
WARNING
Figure 6.1