R
R
R
August 13, 2009
7034-106F
Page 19
Mt. Vernon Pellet Stove (AE)
7
Appliance Set-Up
A. Leg Leveling System
Figure 19.3 - Bolt fully extended
Figure 19.2
Figure 19.1
1.
Thread Allen bolts through nuts until flush.
Figure 19.1.
The Allen bolts and nuts are included in the component
pack inside the appliance firebox.
. Slide assembled nuts and bolts into slots on legs with
the nuts on the bottom.
Figure 19.2
. Use a 5/ in.
(.96mm) Allen wrench to adjust legs up and down to
desired level.
Figure 19.3.
B. Outside Air Kit Instructions
1. Measure distance from floor to air vent opening in appli
-
ance and mark location on wall.
Use saw to cut opening in wall. Cut a -1/ to inch
(89-10mm) opening on inside wall and a to -1/
inch (10-11mm) opening on outside of house.
. Use wire tie to secure flex pipe to collar assembly.
. Slide trim ring over flex pipe and run pipe through wall.
. Attach flex pipe (not supplied) to outside termination
cap with second wire tie.
5. Secure termination cap to outside surface.
6. Secure trim ring to interior wall.
CAUTION
Never draw outside combustion air from:
• Wall, floor or ceiling cavity
• Enclosed space such as an attic or garage
Figure 19.4
T
ermination Cap
Wire
T
ie
T
rim Ring
Wire
T
ie
Collar
inch Aluminum
Flex Pipe
(not included)
Included in Kit
: wire ties, 1 collar assembly,
1 termination cap assembly, 1 trim ring, fasteners.
NOTE:
3 INCH ALUMINUM
FLEX PIPE NOT INCLUDED.
Tools Needed:
Phillips head screw driver; wire cutters;
hole saw or jig saw.
