R
R
R
February 3, 2010
7014-188B
Page 19
CB1200-I Pellet Insert
Left Corner
Piece
Rear Vent Installation Preparation:
1. Remove the ENTIRE exhaust blower housing by remov
-
ing the 4 nuts using a 7/16 inch socket wrench. Set the
nuts aside for later use.
2. Remove the 4 screws and remove the vertical exhaust
transition pipe exhaust blower housing.
3. Remove any silicone sealant remaining on the blower
housing.
4. Attach the rear vent adapter to the exhaust blower hous
-
ing with 4 screws.
Figure 19.2.
5. Apply a bead of high temperature silicone adhesive
around the juncture of the blower housing and rear vent
adapter, smoothing it around the joint to ensure that a
good seal is made.
6. Re-install the exhaust blower housing (now with rear vent
adapter attached) with the 4 nuts previously removed in
Step 1.
7. Use 2 screws to attach left corner filler piece of rear
shroud to the insert hopper.
Figures 18.1 & 18.2 on
page 18.
8. Install the left shroud corner with 2 screws into the hopper
body and 1 down into filler piece.
Figure 19.1.
9. Install cover plate over top vent opening using 4
screws.
Figure 19.1
Figure 19.2
1. Install rear panel using 4 screws along bottom and 2 screws
into the left shroud corner piece at the top.
Figure 19.3
.
2. If your installation does not include an outside air kit,
attach cover plate with 4 screws.
3. Attach left shroud panel using seven screws, 3 on top and
bottom and 1 along the side.
Figure 19.3
.
Top Vent Applications:
Leave knock-out plate in place.
Figure 19.3
Rear Vent Applications
: Clip corners of knock-out plate,
remove and discard, prior to assembling rear shroud kit.
6. Beginning at the right shroud panel drill into hopper body
through the 3 pre-drilled openings and the 2 pre-drilled
openings on the rear shroud panel.
Figure 19.5
. Continue
around to left shroud corner panel at the 2 pre-drilled
openings.
Figure 19.6.
Secure with screws to insert.
7.
For Top Vent Installation:
Install 3 inch or 4 inch (76 or 102mm) top vent adapter.
See circled area in
Figure 18.3 on page 18
. NOTE:
This adapter may be attached to outside venting prior to
latching it on to the top vent pipe.
Attaching Shroud to Hopper Body:
Installing Rear Shroud
4. Assemble the right corner and right panel pieces using 4
screws prior to attaching to insert.
Figure 19.4.
5. After assembly, attach the right shroud panel/corner piece
assembly to the insert with 3 screws across the bottom and
1 on the side.
Figure 19.4.
Attach right
corner piece to
side panel first.
Right Corner Piece
Right Side
Rear Panel
Outside Air
Cover Plate
Knock-Out
Plate
Rear Panel
Left Side
Drill Holes
Drill Holes
Right Side
Rear Panel
Drill Holes
Left Side
Rear Panel
Figure 19.5
Figure 19.3
Figure 19.4
Figure 19.6
