24
7014-285A
October 9, 2017
CB1200 Pellet Insert
Figure 24.1
Figure 24.2
Figure 24.3
Figure 24.4
Panel Locator Hole
5. Hold side curtains in open position and lower panel set
over insert setting lower edge of top panel in slot between
hopper lid and panel support as shown in
Figure 24.5
.
Place existing screw head (installed in
Figure 24.6
) into
locater hole in floor of insert.
Figure 24.6.
6. Lift hopper lid and press down on panel top while installing
(4) 8-32 x 3/8 inch screws into holes in panel support. (If
screws have been factory installed, tighten to secure panel
to panel support.) Return hopper lid to closed position.
7.
Install a corner bracket on each side trim piece. Slide
brackets into top trim from each side and secure with
flathead screwdriver. Attach trim assembly to panel set
as follows:
a. Ensure that brackets face towards the back.
b.
Align trim assembly to panel set sides and slide down.
Figure 24.5
Figure 24.6
F. Panel and Trim Set (Cont’d)
