2. Thermostat Location and Wiring to Fireplace
The kit comes with a programmable wall thermostat
(C1)
and 25’ of thermostat wire
(C2)
. If you need to run more
than 25’ make sure you use a continuous strand of 18 to
22 gauge thermostat wire. For optimum performance your
thermostat should be:
• Mounted on an inside wall, approximately 5’ above the
floor
• Do not locate where there is poor air circulation such
as in a corner, alcove, behind doors, bookcase or
other objects
•
Located away from drafts, direct sunlight, above a
lamp, television, radiator, a wall next to a window, or
direct heat from the appliance
• Avoid damp environments as this can lead to corrosion
that may shorten thermostat life
•
If painting or construction work around, cover the
thermostat completely or wait until work is complete
before installation.
• The thermostat wire will be installed on the opposite
side of where the electric comes in at. See Figure 3.6.
Fan Air
Cover Plate
Outside Air
Cover Plate
Fan Air
Outside Air
Outer cover plate
for thermostat wire
Figure 3.6
• Remove the outer thermostat wire cover plate and
insert the end of the wire with the spade ends on it
through the hole in the cover plate. See Figure 3.6.
Continue inserting the wire into the fireplace and
through the hole in the inner cover plate. See Figure
3.7.
•
Reinstall outer thermostat cover plate. See Figure 3.9.
Wire through
large hole.
Figure 3.8
Figure 3.9 Thermostat wire installed through outer cover
plate
Outer thermostat
wire cover plate
Inner thermostat wire
cover plate
•
Open the lower access panel on the front of the
fireplace. Locate the end of the thermostat wire and
run it in through from the back of the large hole and up
to and attach it to the terminal block. See Figure 3.8.
Figure 3.7
11
Quadra-Fire • Pioneer III Owner’s Manual • 4182-900 • Rev D • 08/19
