Quadra-Fire • QFI30, QFI35 • 2227-900 Rev. H • 1/11
34
Log #2 (SRV2225-703)
: Mate the grate tine with the slot on the bottom of Log #2. The back end of the log rests on the log
support. The side of the log will contact the left refractory as shown in Figure 7.
Figure 7. Place Log #2
Figure 8. Slot on Log #2
Figure 9. Place Log #3
Log #3 (SRV2225-702)
: Position the left end of the log on the fl at spot of Log #2 as shown in Figure 7 and Figure 9. The
right end of the log rests on the log support and touches the back refractory. The left end of the log should contact the left
refractory panel.
Log #4 SRV(2225-705)
: Mate the slot on the bottom of Log #4 with the right log pin. Refer to Figure 11 for location of log
slot. Rotate the right end of the log clockwise until the groove on the end of the log mates with the grate bar.
Figure 10. Place Log #4
LOG CONTACTS
LEFT REFRACTORY
PANEL
FLAT SPOTS
FOR LOG #6 AND LOG #3
MATE SLOT WITH
GRATE TINE
SLOT
LOG CONTACTS LEFT
REFRACTORY PANEL
POSITION LOG
ON FLAT SPOT
LOG CONTACTS
BACK REFRAC-
TORY PANEL
FLAT SPOT
FOR LOG #7
LOG RESTS ON
LOG SUPPORT
MATE LOG
PIN WITH
LOG SLOT
MATE GRATE BAR
WITH LOG GROOVE
2
3
4
Figure 5.
Log #1 (SRV2225-701)
: Position the groove on the log with the right grate tine as shown in Figure 6. The opposite end of
the log will rest on the log support. Rotate the opposite end of the log clockwise until it contacts the refractory panel.
Figure 6. Location of Log #1
LOG SUPPORT
ANDIRONS
OUTER TINES
LOG PINS
PILOT
BRACKET
LOG RESTS ON
LOG SUPPORT
LOG GROOVE
CONTACTS
GRATE TINE
1
