Page 1
September 1, 2008
R
7007-161H
2700-I WOOD INSERT (ACT)
pANEL and TRIM SET
panel & Trim Assembly Instructions
NOTE: you have an option of installing the trim on
the panels before securing the assembly to the insert
or slide trim over the panels after panels are installed.
Pre-installing the trim allows for installations that
may have a mantel already in place or where space
is restricted.
1. Lay the panel set face down on protective covering to
prevent scratching the painted surface.
2.
Secure panel set together with screws provided.
Figure
13.1.
. Assemble the trim pieces using the “L” brackets.
Figures
13.1 and 13.2
.
4. Slide the trim over the panel assembly. (See Note
above).
Included in Kit:
(2) side panels, left and right; (1) panel
top; (2) side trim, left and right, (1) top trim (2) “L” brackets,
fastener package and (2) outside air cover boxes
Tools Required:
Phillips head screw drive
r
View of "L" Bracket
installed
Figure 13.1
Attaching Panels and Trim to the Insert
1. Remove the insert top (if installed) by lifting up slightly
then pulling towards you and set aside.
See Figure 14.1
on page 14.
2. There are 2 locator pins on the top of the insert to match
up with alignment holes on the back flange of the panel
set.
Figure 13.3
. On the bottom of ea
ch side of the insert face is a peg.
The bottom of the panel leg will hook onto this peg.
Figure 13.3
4. Using both hands, hold the panel & trim assembly and
slide it onto the locator pins and then hook the bottom of
the panel legs to the pegs.
5. Place the insert top back into position.
See page 14.
Screw side
panels to top
panel
"L" Bracket
Locator pin
Slide panel over
locator pin
Hook bottom of
panel leg over
peg
The Outside Air Cover Boxes must be installed
on both panels legs FIRST before installing the
panels on the insert. See page 12.
Figure 13.2
Figure 13.3
