Page 15
September 1, 2008
R
7007-161H
2700-I WOOD INSERT (ACT)
ZERO CLEARANCE ADJUSTABLE
TRIM SUPPORT, 2 inch to 10 inch
Included in Kit:
1 trim top; 1 trim front; 2 trim sides;
double-sided tape (already installed)
Tools Required:
Phillips head screw driver; sheet metal
shears; measuring tape; gloves
1. The 10 screws on each set of scissors will already be
loose when shipped.
2. Expand scissors to desired height. Tighten screws to
hold in place using Phillips head screw driver.
Figures
15.1 and 15.2.
. Measure trim to required height to cover scissors and
mark piece for cutting. Cut excess material from
top
of
trim’s edge, not bottom. This edge will be sharp; wear
gloves to prevent injury to your hands.
Figure 15.2.
4. Using sheet metal shears, cut trim along the marked
edge. The cut edge fits under lip of top, so it allows for
some variance in your straight edge.
5. The double-sided tape that holds the scissors has a par-
ticularly powerful bonding adhesive. Adjustments are
extremely difficult once trim has adhered to tape. Do a
dry run first without removing paper from tape.
6. Place cut edge of trim under top lip and into position on
scissors. Install the 2 side pieces first. The front piece
corners will overlap the side pieces.
NOTE:
The trim in
the Flush Mount Kit is one piece.
7. Once you are satisfied with the positioning, remove trim
and set aside.
8. Remove the paper from double-sided tape that is to
accept trim side. Align side and then press hard against
tape to secure side piece.
9. There are holes in the back flange of the top to secure
it to the wall if necessary. Use the appropriate fastener
for the type of wall material in your installation.
NOTE
: /8 inch (9.5mm) thick tile or like material can be cut
to size and fit under lip of top trim edge for a decorative touch.
Figure 15.3.
Decorative tile may
be installed
DOUBLE-SIDED TAPE
DOUBLE-SIDED TAPE
SCREWS ARE CIRCLED
EXpLODED VIEW OF SCISSORS
Figure 15.1
INSTALL FRONT TRIM LAST.
CORNERS OVERLAP SIDE
TRIM PIECES
EXPAND SCISSORS TO DESIRED HEIGH T
CUT TOP EDGE OF TRIM,
NOT BOTTOM EDGE
Figure 15.2
Figure 15.3
•
Gloves recommended
• May have sharp edges
CAUTION
Injury Risk.
