Page 27
Cumberland Gap Wood Stove
R
September 1, 2008
7006-188E
MAINTENANCE (Con'd)
1
1
1
1
2
2
3
3
7
4
5
5
5
6
6
5
5
5
5
BRICK REPLACEMENT INSTRUCTIONS
Brick Set Part Number: BRICK-7006
The firebox of your Quadra-Fire Cumberland Gap is lined with high
quality firebrick which has exceptional insulating properties. There is
no need for a grate, simply build a fire on the firebrick.
1. Be certain coals are completely cold. Remove all old brick and
ash from unit and vacuum out firebox.
2. Remove new brick set from box and lay out to diagram as
shown.
3. Lay bottom bricks in unit.
4. Install rear bricks on the top of the bottom bricks. Slide top of
bricks under clip on back of firebox wall and push bottom of brick
back.
5.
Install side bricks. Slide top of brick under clips on side of firebox
and push the bottom of the brick until it is flush with the side of
the unit.
Use Part 832-0550 when
ordering individual brick.
Provide brick dimension
or copy this page, mark
the desired brick and
take it to your authorized
dealer.
1. Remove all ash from firebox, and extinguish all hot embers before disposal
into a metal container.
2. Remove ceramic blanket & baffle together
3. With a 3/16” Allen wrench, remove the front manifold tube retainer bolts on
the air channel under the end of the front tube.
See Figure 27A.
NOTE
:
Soak the bolts with penetrating oil for at least 15 minutes before trying to
remove them.
4. To remove manifold tube, slide the tube to one side until one end is out of
its hole. Then, while lifting that end of the fiber board baffle, pull tube up
over the air channel and out of hole at the other end.
5. Slide fiber board baffle forward to front of stove and straight out through
door.
See Figure 27B.
6. To install the fiber board baffle, repeat steps 2 through 4 in reverse.
7. The front manifold tube is shorter than the back two. It is IMPORTANT
that they are replaced in the correct position or your stove will not operate
properly.
8. Be sure the fiber board baffle and ceramic blanket are fully pushed back
into position and the blanket is down flat. The front of the blanket should
be flush with the front of the baffle.
NOTE
: The baffle in the Cumberland Gap is 2700° Fiber Board. Removing
hardware exposed to combustion processes can be frustrating. If your reason
for removing the baffle is simply to clean the chimney, you have alternatives
which will save time and effort. Call a qualified chimney sweep or an authorized
Quadra-Fire dealer for details.
BAFFLE REMOVAL & INSTALLATION
Ceramic Blanket
Baffle Board
Push baffle board up slightly to
allow room to turn the handle
Baffle Board
Figure 27B
Figure 27A
6
6-1/2"
4-1/2"
2.0"
2
4-1/2"
9.0"
1-1/2"
4-1/8"
1-1/4"
Nbr
Brick Size
Qty
1
9" x 4-1/2" x 1-1/4"
4
2
9" x 4-1/2" x 1-1/4”
with hole
(see drawing)
2
3
9” x 2-1/4" x 1-1/4"
2
4
3" x 2-1/4" x 1-1/4"
1
5
6-3/4" x 4-1/2"
7
6
6-1/2" x 4-1/4" angled
(see drawing)
2
7
9" x 2" x 1-1/4"
1
