Page 3
Cumberland Gap Wood Stove
R
September 1, 2008
7006-188E
SERIAL NUMBER LABEL & LOCATION
..................2
PRE-USE CHECKLIST
..............................................3
LISTINGS & SAFETY NOTICES
...............................4
INSTALLATIONS MATERIAL NEEDED FOR SAFETY
4
VENTING SYSTEM
........................................................ 4
DIMENSIONS & VENT SPECIFICATIONS
................5
CLEARANCE TO COMBUSTIBLES
.........................6
FLOOR PROTECTION
..............................................7-8
ALTERNATE FLOOR PROTECTION
........................8
INSTALLATION
Locating your stove .............................................9
Side door locking mechanism ..............................9
Leg leveling system .............................................9
Reversible flue collar ............................................10
Chimney height requirements, 2-10-3 Rule .........11
Chimney
connector
..............................................11
Masonry
chimney
.................................................12
Solid pack chimney with Metal supports
as a thimble ..........................................................13-14
Masonry fireplace .................................................14
Metal prefabricated chimney ................................15
Mobile home installation ......................................16
Outside air kit installation .....................................17
Optional Blower installation ..................................17
Baffle Diverter Installation ....................................18-19
OPERATION
Over-firing your appliance ....................................20
Burning
process
...................................................20
Air
controls
...........................................................21
Heat output setting ...............................................22
Building a fire .......................................................22
Correct baffle & blanket placement ......................23
Opacity
.................................................................24
Burn
rates
............................................................24
Wood selection and storage.................................24
Blower operating instructions ...............................24
MAINTENANCE
Creosote formation & removal .............................25
Chimney
cleaning
................................................25
Ash
removal
.........................................................25
Glass care & replacement ....................................25-26
Care & cleaning of plated surfaces ......................26
Door gasket & door handle assembly .................26
Brick
replacement
................................................27
Baffle removal & installation .................................27
PARTS DIAGRAM
.....................................................28
SERVICE PARTS & ACCESSORIES
........................29-30
SERVICE & MAINTENANCE LOG
............................31
WARRANTY POLICY
................................................32
CONTACT INFORMATION
........................................36
TABLE OF CONTENTS
PRE-USE CHECK LIST
CAUTION!
DO NOT TILT THE UNIT ON THE CAST IRON LEGS.
Lift the unit upright and place it into position on the floor
protector.
1.
Place the unit in a location near the final installa-
tion area and follow the procedures below.
2.
Open the stove and remove all the parts and
articles packed inside. Inspect all the parts and
cast iron body for shipping damage. Contact
your dealer if any irregularities are noticed.
3.
All safety warning have been read and fol-
lowed.
4.
This Owner's Manual has been read.
5.
Floor protection requirements have been met.
6.
Chimney connector is properly installed.
7.
The proper clearances from the stove and chim-
ney to combustibles materials have been met.
8.
The masonry chimney is inspected by a pro-
fessional and is clean, or the factory-built
metal chimney is installed according to the
manufactuer'rs instrucitons and clearances.
9.
The chimney meets the required minimum
height.
10.
All labels have been removed from the glass
doors.
11.
Plated surfaces have been wiped clean.
