7019-230J
October 23, 2018
20
SANTA FE PELLET INSERT
Figure 20.1
Grille Bracket Cover
(shipped flat from factory)
Finger bend into position
after grilles are installed
on appliance
Insert heat exchanger rods
through holes on second grille.
Heat Exchanger
Rods
Install bottom 3 grilles before
installing single top grille
Install in flat position
Bend after grilles installed
C. Optional Grille Removal and Installation
Included in Kit:
(4) lower grilles; (3) upper grilles, (1)
upper grille; (4) grille bracket covers; fasteners
Tools Required:
#2
Phillips head screwdriver
1.
Open the door. Remove the top 2 screws on each side
of upper grille and remove the single grille. Remove the
bottom 2 screws on each side and remove the 3 grilles
attached together.
2.
Removing the ash drawer before taking off the lower
grille will make the lower grille easier to remove. Using
a Phillips head screwdriver, remove the 2 screws on
each side and pull forward with a downward motion to
avoid catching the grille on the fire pot pull rod.
NOTE:
The plated grilles, Nickel, Black Nickel and Gold,
have 4 black grille bracket covers to eliminate
the brightness of the bracket plating. The bracket
covers are shipped flat, installed on the grilles, and
after the grilles are installed on the appliance they
are then finger-bent into position.
3.
Attach the 4 grille bracket covers to the lower 4 grilles
and the top 3 grilles. Slip the metal strips through
the grille openings and secure to grille with screws
provided. Do not finger bend the cover brackets at this
time.
4.
Secure the lower grille to the appliance with 2 screws
on each side. Finger bend the bracket covers around
the plated brackets.
5. The upper grille has 2 separate parts. Install the
3 grilles attached together first. Angle the grilles
downward and insert the heat exchanger cleaning rods
through the holes in the second grille and then twist
forward until horizontally level. Attach the grille with
only the bottom 2 screws on each side of grille. Do not
finger bend the cover brackets at this time.
6. Position the single top grille over the 3 already in place.
Attach with one screw on each side through the top
grille and the other 3 grilles to secure to appliance.
7.
Finger bend the bracket covers on the upper grille into
place.
8.
Re-install the ash drawer.
D. Door Handle Removal
Tools Required:
5/32 Allen wrench
1.
Open the door. Using a 5/32 Allen wrench, loosen set
screw by a couple of turns, but do not remove.
2.
Push the pin completely out and remove the handle.
3.
Re-install in reverse order.
E. Door Removal
1.
Remove the door handle and face. Follow instructions
from D above.
2.
The door can now be lifted off the hinges.
3.
Re-install in reverse order.
