7019-230J
October 23, 2018
6
SANTA FE PELLET INSERT
C. Tools And Supplies Needed
B. Thermostat Wall Control Location
The thermostat wall control’s location will have some affect
on the appliance’s operation.
•
Maximum wire length from appliance is 100 feet
(30.48m) continuous non-spliced wire. Recommended
20 gauge wire, solid copper
.
•
When located close to the appliance, it may require a
slightly higher temperature setting to keep the rest of
the house comfortable.
•
When located in an adjacent room or on a different
floor level, you will notice higher temperatures near the
appliance.
D. Inspect Appliance and Components
•
Open the appliance and remove all the parts and
articles packed inside the Component Pack. Inspect all
the parts and glass for shipping damage.
•
Report to your dealer any parts damaged in shipment.
•
All labels have been removed from the glass door.
•
Plated surfaces have been wiped clean with a soft
cloth, if applicable.
• Read all the instructions before starting the
installation. Follow these instructions carefully
during the installation to ensure maximum safety
and benefit.
•
Follow pipe manufacturer instructions for installation
and air clearance requirements.
Reciprocating Saw
Channel Locks
Hammer
Phillips Screwdriver
Tape Measure
Plumb Line
1/4” Self-Tapping Screws
Tools and building supplies normally required
for installation, unless installing into an existing
masonry fireplace:
Framing Material
Hi-temp Caulking Material
Gloves
Safety Glasses
Framing Square
Electric Drill & Bits (1/4”)
Level
May also need:
Vent Support Straps
Venting Paint
WARNING
Fire Risk.
Damaged parts could impair safe operation. Do
NOT install damaged, incomplete or substitute
components.
WARNING
Hearth & Home Technologies disclaims any
responsibility for, and the warranty will be voided
by, the following actions:
•
Installation and use of any damaged appliance.
•
Modification of the appliance.
•
Installation other than as instructed by Hearth &
Home Technologies.
•
Installation and/or use of any component part not
approved by Hearth & Home Technologies.
•
Operating appliance without fully assembling all
components.
•
Operating appliance without legs attached (if supplied
with appliance).
•
Do NOT Over fire
Or any such action that may cause a fire hazard.
