RR
R
November 2, 2005
7001-142C
Page 19
Santa Fe Pellet Stove
D. Optional Log Set Placement Instructions
Figure 19.1
4 PIECE LOG SET INSTALLATION
OPTIONAL TOP LOG
Figure 19.2
Figure 19.3
CAUTION
Logs are FRAGILE. Use extreme care when handling or
cleaning logs.
NOTE:
Due to the abrasive nature of a pellet appliance fire, the
logs are not covered under warranty. Any placement varia-
tion other than shown here can cause excessive heat and
shall void the appliance warranty.
1. Place the right rear log as shown. There is a notch in the
bottom of the log for clearance for the thermocouple and
thermocouple cover (ceramic protection tube).
Figure
19.1
2.
Continue placing the last 3 logs around the firepot as
show in
Figures 19.2, 19.3
and
19.4
.
Be careful not to
block the drop tube in the back of the firebox where pel-
lets feed into the firepot.
Place the top log over the firepot. It will be about 2-
1/2 inches (64mm) above the firepot when in place.
Notice the position of the top log as it rests on the 3
logs in a stable position to prevent it from falling into
the firepot. The charred area on the back of the top
log faces the back, not the front.
Figure 19.5
Drop Tube
Notch
Thermocouple
Cover
Figure 19.4
Figure 19.5
Figure 18.3 - Rear Vent Adapter
