Page 20
7001-142C
November 2, 2005
Santa Fe Pellet Stove
R
R
R
E. Optional Gold or Nickel Grille & Trim Ring
1
. While holding door to face, remove 2 screws from
grille and remove existing grille.
Figure 1.
2. Install new grille using screws removed in step 1.
Ensure that screws are inserted through the grille, rib
and door.
Included in Kit
:
(1) Grille
Tools Required:
Phillips head screwdriver
1. Installing the Grille
Included in Kit
: (1) Trim Ring, (6) 8-32 nuts
Tools Required:
Phillips head screwdriver, 11/32”
wrench or nut driver
1. Face can be removed with the door on or off the appli-
ance. Remove the grille before removing face to prevent
it from falling foward and potentially causing damage.
2. Tilt the top of the face foward until the top rib clears the
door, then slide the face down until the locating screws
on the bottom rib are completely out of the door.
Figure 20.2
2. Installing the Trim Ring
Rib
Face
Grille
Door
Remove 2 screws
Rib
Locating screws on rib are the
2 outside holes on each side
Figure 20.1
Start with
straight edge
Lift up so top rib
can clear the door
Slide face down
until locating screws
are out of door
Figure 20.2
Figure 20.3
Figure 20.4
3. Lay the face, face-down on a protective coating to avoid
scratching.
4. Remove the 6 nuts from the back side of the face and
discard the stud and nuts.
5. Turn the face over so it is front side up. Locate studs
on the trim ring. Starting with one straight side of trim
ring, insert the studs into the holes in the face. After
the first 2 studs have dropped into their holes, carefully
lay the trim ring down until all of the studs are in place.
Figure 20.3.
6. Hold the trim ring in place and turn the face over to
expose the back side.
Figure 20.4.
7. Place 8-32 nuts, included in the kit, on all 6 studs and
gently tighten them.
8. Reverse steps 1 and 2 to re-install face and the grille.
