RR
R
November 2, 2005
7001-142C
Page 33
Santa Fe Pellet Stove
D. Igniter Replacement
E. Baffle & Brick Removal
a. Shut down the appliance by turning down the thermostat
and let the appliance completely cool down
.
After the
appliance has cooled down, unplug it and remove the
ash drawer.
b. The wire leads to the igniter are connected to the wire
harness with 1/4 inch male / female spade connectors.
Disconnect the spade connections and remove the
igniter from the chamber. Use a Phillips Head screw
driver to remove set screw and slide igniter out.
c. Install new igniter into the chamber and replace the
screw. Re-connect the wires to the 2 leads with the
spade connectors.
d. Double check that the igniter wires are clear of any
movement, i.e. ash drawer, firepot cleaning rod,
cleaning slide plates, etc.
f. Re-install the ash drawer and side panel and re-connect
the power.
Thumb Screw
Igniter
Firepot
Figure 33.1
Figure 33.2
Figure 33.3
1. Appliance must be completely cool.
2. Open door and located baffle at top of inside of firebox.
3. The baffle is secured to the right bracket. A tab on the
baffle is inserted into a notch on the right bracket. Lift the
baffle up, out of the notch and towards you.
See Figure
33.2
. The left side of the baffle has a hook that rests on the
top edge of the brick. This side will just lift off.
4. Remove right brick by pulling up and then towards you to
expose the exhaust venting for cleaning.
Figure 33.3.
Hook on
left side
Tab on
right side