Quadra-Fire SANTAFEI-C, Owner'S Manual

27

04/21

7019-802H

D. Igniter

PART NUMBER: 

SRV7000-462

1.  Shut down the appliance by turning down the 

thermostat

and let the appliance completely cool down

.  

After the appliance has cooled down, unplug it and 

remove the ash drawer.

2.  The wire leads to the igniter are connected to the wire 

harness with 1/4 inch (6mm) male / female spade 

connectors. These wires will pull forward approximately 

4 to 5 inches (102mm to 127mm) through the grommet 

at the back of the ash drawer chamber. Disconnect 

the spade connections and remove the igniter from 

the chamber. Loose the thumb screw and slide igniter 

out 

(Figure 27.1)

.

3.  Install new igniter into the chamber and tighten the 

thumb screw. Re-connect the wires to the 2 leads with 

the spade connectors.

4.  Push excess wire leads back through the grommet, one 

wire at a time, to take-up the 4 to 5 inches (102mm to 

107mm) previously pulled out. This will keep the wires 

out of the way of the ash drawer. Double check that 

the igniter wires are clear of any movement, i.e. ash 

drawer, fire pot cleaning rod, cleaning slide plates, etc.

5.  Re-install the ash drawer and then re-install the side 

panel and re-connect the power.

Figure 27.1

Igniter

Igniter Bracket

Thumb Screw

E. Glass

PART NUMBER: 

SRV7021-032

1. 

Open the face and remove door from the appliance by 

lifting door off of hinge points and lay on a flat surface 

face down.

2. 

Using a flat head screwdriver pry out rope from door 

and clean any silicone around the screw heads.

3.  Using a Phillips head screwdriver remove the seven 

screws and set aside.

4.  Remove glass retainers and set aside.

5.  Remove old glass assembly and discard.

6.  Lay new glass assembly in place.

7.  Add glass retainers.

8.  Using a Phillips head screwdriver fasten glass retainers 

to door assembly ensure glass assembly is centered 

within the frames.

9.  Add rope into crevice as shown below in 

Figure 27.2.

10. Re-install door and close face to appliance.

Figure 27.2

Screws

Rope

Glass Retainers

Glass 

Assembly

Door Assembly

Handle glass with Care.

•  Glass is 5mm thick high temperature heat-

resistant ceramic glass.

• 

DO NOT REPLACE with any 

other material.

•  Alternate material may shatter and 

cause injury.

WARNING

CAUTION

Shock Risk.

• 

Do NOT remove grounding prong 

from plug.

•  Plug directly into properly grounded 3 

prong receptacle.

•  Route cord away from appliance.

• 

Do NOT route cord under or in front 

of appliance.