Page 22
7019-221C
November 14, 2011
R
Santa Fe Pellet Insert
1. Open door to expose the fi rebox.
2. Positioning the logs.
Place the right rear log as shown. There is a notch in
the bottom of the log for clearance for the thermocou-
ple and thermocouple cover (ceramic protection tube).
Figure 22.1.
Continue placing the last 3 logs around the fi repot as
show in
Figures 22.2, 22.3
and
22.4
.
Be careful not to
block the drop tube in the back of the fi rebox where pel-
lets feed into the fi repot.
Figure 22.5
Four Piece Log Set Installation
Optional Firepot Top Log Installation
Figure 22.1
Figure 22.2
Figure 22.3
Figure 22.4
Place the log over the fi repot. The charred
area on the log is turned toward the back, not
the front.
The log will be about 2-1/2 inches (64mm)
above the fi repot when in place. It must rest
on the 3 logs in a stable position to prevent it
from falling into the fi repot.
Figure 21.5.
H. Optional Log Set Placement Instructions
CAUTION
Logs are FRAGILE. Use extreme care when handling or
cleaning logs.
NOTE:
Due to the abrasive nature of a pellet appliance fi re, the
logs are not covered under warranty. Any placement vari-
ation other than shown here can cause excessive heat
and shall void the appliance warranty.
Notch
Thermocouple
Cover
Drop Tube
