20
7019-230C
May 18, 2015
Santa Fe Pellet Insert
F. Adjustable Hearth Support
Size: 9”d x 45”w, 2” to 10” Height Adjustment
Included in Kit:
(1) trim top, (1) trim front, (2) trim sides,
double-sided tape (already installed)
Tools Needed:
Phillips head screwdriver, sheet metal
shears, measuring tape, gloves
1. The 10 screws on each set of scissors will already be
loose when shipped.
Figure 19.1.
2. Expand scissors to desired height. Tighten screws to
hold in place using Phillips head screwdriver.
Figure
19.2.
3. Measure front and side trims to required height to cover
scissors and mark pieces for cutting. Cut excess mate-
rial from
top
of trims edge, not bottom. This edge will
be sharp; wear gloves to prevent injury to your hands.
Figure 19.3.
4. Using sheet metal shears, cut trim along the marked
edge. The cut edge fi ts under lip of top trim, so it allows
for some variance in your straight edge.
5. The double-sided tape that holds front and side trims to
scissors has a powerful bonding adhesive. Adjustments
are extremely diffi cult once trim has adhered to tape. Do
a dry run fi rst without removing paper from tape.
6. Place cut edge of trim under top lip and into position on
scissors. Place side pieces on fi rst and then front piece.
The front piece overlaps side pieces.
7. Once you are satisfi ed with the positioning, remove trim
and set aside.
8. Remove the paper from double-sided tape that is to
accept trim side. Align side and then press hard against
tape to secure side piece. Repeat for other side. Install
front trim piece last.
9. There are 3 holes in the back fl ange of the top to secure it
to the wall if necessary. Use the appropriate fastener for
the type of wall material, i.e., brick, sheetrock, etc.
NOTE
: 3/8 inch (9.5mm) thick tile or like material can be
cut to size and fi t under lip of top trim edge for a decora-
tive touch.
Figure 19.3.
Figure 19.1
Figure 19.2
Figure 19.3
Figure 19.4
WARNING
Sheet metal trim edges will be sharp. For safety
purposes wear gloves.
Injury can occur.
DOUBLE-SIDED TAPE
DOUBLE-SIDED TAPE
SCREWS ARE CIRCLED
EXPLODED VIEW OF SCISSORS
Decorative tile
may be installed
INSTALL FRONT TRIM LAST.
CORNERS OVERLAP SIDE
TRIM PIECES
EXPAND SCISSORS TO DESIRED HEIGHT
CUT TOP EDGE OF TRIM,
NOT BOTTOM EDGE
