20
Quadra-Fire • Sapphire • 7055-116 Rev. G • 10/12
Chimney Liner
Termination Cap
Co-Axial to
Co-Linear
Connector
30 ft. (9m) of 3 in.
(76mm) Flex Liner
Exhaust Section
(Cut to length)
Pipe Length
Optional
4 ft. (1m) of 3 in. (76mm) Flex
Liner Air Intake Section
The chimney must be sealed
from the 4 ft. (1m) section to
termination using a smoke
shelf or a flue restrictor.
The seal should be 6 in.
(152mm) below the end of
the 4 ft. (1m) Air Intake
section.
This section of the
chimney must be
sealed
Chimney Liner
Termination Cap
Co-Axial to
Co-Linear Connector
3 in. (76mm)
Flex Liner
Pipe Length
(Optional)
Showing (2)
30 ft. (9m)
Sections of
Flex Liner
4. Existing Masonry Chimney
Type A
Type B
Type C - Up & Out Installation
Type D - Hearth Mount
Figure 5.25
Type A & B Co-Axial to Co-Linear
Termination Cap
Flashing
4 in. (102mm)
Flex Liner
Top Adaptor
Retro Connector
90° Elbow
Direct Vent
Pipe
Chimney Liner
Termination Cap
30 ft. (9m) of 3 in. (76mm)
Flex Liner Exhaust Section
(Cut to length)
4 ft. (1m) of 3 in. (76mm) Flex
Liner Air Intake Section
Chimney must be sealed
from 4 ft. (1m) section to
termination using a smoke
shelf or a flue restrictor.
Seal should be 6 in.
(152mm) below end of 4 ft.
(1m) Air Intake section.
This section of the
chimney must be sealed
Co-Axial to Co-Linear Connector
Alcove Clearance to
Combustibles must be
maintained.
