21
September 27, 2018
7082-153D
TREKKER INSERT
Figure 21.3
Figure 21.2
Included in Surround & Trim Kit:
(2) corner brackets and
set screws; (1) trim set, 3 piece; (2) side panels; (1) top
panel; (4) screws.
Tools Needed:
Powered Phillips head screw driver
1. Secure the top panel to the surround sides with the
screws provided
(Figure 21.1)
.
2. Assemble the trim with the (2) corner brackets provided
(Figure 21.2)
.
3. Remove the 2 cast sides and slide the assembled trim
over the assembled surround set
(Figure 19.3 on pg
19)
.
4. Carefully slide surround and trim over the top of the
insert into place matching the mounting holes on the
panel with the mounting holes on the insert. Secure
with screws provided
(Figure 21.3)
.
Back of Top Surround
Back of Side Surround
Screws
Figure 21.1
Shown with trim installed on panel set.
2 PIECE LOG SET INSTALLATION
1.
Place the left log as shown. There are 2 indentations in
the bottom of the log to fit over the screw heads in the
firebox
(Figures 21.4 & 21.5)
.
2.
Place the right log in front of the 2 screw heads in the
firebox
(Figures 21.6 & 21.7)
.
NOTICE:
Due to the abrasive nature of a pellet appliance
fire, the logs are not covered under warranty.
Any placement variation other than shown
here can cause excessive heat and shall void
the appliance warranty.
Figure 21.4
Figure 21.5
Log fits over screws
Left Log
Log has indentations on the
bottom to fit over the screw
heads.
Log rests in front of screws
Right Log
Figure 21.6
Figure 21.7
F. Surround & Basic Trim Set
G. Optional Log Set Instructions
CAUTION
Logs are FRAGILE. Use extreme care when handling or
cleaning logs.
