4
Install the 8mm hex head bolts through
the pinch weld and the mounting
brackets with washers on both sides
and secure with a 8mm nylock nut
using a 13mm hex wrench and a 13mm
socket. (FIG 3)
Do not fully tighten at this time.
Repeat on the other side bracket holes.
(FIG 4)
Brute Strength Side Steps Installation:
Locate the (3) vertical threaded holes
behind the pinch weld. Align the holes
in the brackets with these holes.(FIG 5)
Install the 8mm hex bolts, lock washers,
and washers using a 13mm socket.
Repeat on other verticle holes. (FIG 6)
Do not fully tighten at this time.
Then, holding the side step up on center
with the pin weld holes fully tighten the
8mm pinch weld hardware. Once snug,
you may now tighten the vertical 8mm
bolts underneath. Repeat all steps on
the opposite side.
Installation is complete.
TORQUE FOR 8MM HEX HEAD BOLTS = 22 FT-LBS
FIG 3
FIG 4
FIG 5
FIG 6
BRUTE_SIDE_STEPS_JL4_12057_0271_A4.qxp_A4 2/26/20 5:20 PM Page 4
