7
Step 4: Installing the Center Bow to the Door Surrounds
Locate the Center Bow assembly with
the pre-installed quick release knuckles
on the ends. With the top folded back as
shown in FIG20, locate the bottom
rear-most bracket hole (FIG21) and slip
the rear bow through the webbing strap
loop located on corner of the top deck
(Fig 21A).
Place the Quick Release knob into the
hole on the rear of the bow mount
bracket (Knob facing out) pull the knob
out and down over the bracket until you
hear a “click” (FIGs 22 & 23). Repeat
this procedure (including the placement
of the bow through the installed web-
bing strap loop) on the opposite side of
the vehicle completing the installation
of the center bow to the door surrounds.
Note the center bow will be attached to
the soft top but the images above
show the bow separate from the fabric
for illustration purposes.
FIG21
FIG21A
FIG22
FIG23
Step 5: Installing the Top Deck to the Jeep
®
With the over door bows installed in the
bow mount brackets, fold the top and
header forward so it rests on the wind-
shield (FIG24). Un-clip the sun visors
and pull the top down to engage the
header clamps on each side of the
windshield and secure the Header to
the windshield (FIGs 25, 26 & 27).
FIG24
FIG25
Q_TJ_ADV_11113.00XX_LTR_BU.qxp_QTOP 6/16/20 12:11 PM Page 7
