The Trusted Source
®
7
Step 6: Header Corner Pockets
Slip the corner pocket sewn into the top
between the header and position the
cable anchors over the two holes with
the cable facing the outside of the
header (Fig 20 & 21).
Cable Anchor
Fabric Pocket fits over Header
FIG 20
FIG 21
Installation:
Note: Figs 20 & 21 bows folded back to rear of vehicle. Rear corner shown.
Step 7: Install Header Foam
Locate the Header foam packet and
attach foam over the installed cable
anchors on each side of the header.
Install the small “strip” foam on
the front of the header as shown
in Fig 22.
FIG 22
Cable Anchor Foam
Strip Foam
Step 8: Drape the Top Fabric
Drape the top fabric over the cab rein-
stalling and securing the bow assembly
above the door. The front header should
be resting on the windshield but not
attached/clamped and the top fabric
should be laid back but not attached
to the rear bows. See Fig 23
FIG 23
JK_07-18_LTR_PRINT_JJ.qxp_Layout 1 2/19/18 11:16 AM Page 7
02192018112320
