Installing the hook mount assembly
12
Step.1
Place hook mount assembly (A) under the hitch ball mount (B) (not
included), secure in place using hitch ball (C) split washer (D) and nut (E).
Tighten firmly.
Note
:
The hook mount should be flat with the underside of the
support.
B
D
A
E
C
CAUTION : You must add a 2” receiver hitch on the
ATV/UTV to install the Q-Lock universal attachment kit
(Not included). List page 29 & 30.
Failure to follow this step could cause serious damage
to the hitch ball mount or the ATV/UTV.
2” receiver hitch (Not included)
Step.2
Warning
: You must ensure that once the coupling hook (F) is mounted on the hook mount (A) you have enough clearance between the underside
of the hook and ground (G) so as not to interfere with the operation of the suspension, in addition check the distance between the top of the push
chanel and the underside of the ATV/UTV (H) so that the plow blade can be raised properly.
If not, reverse the hitch ball mount or replace it with a straight ball mount or a ball mount with less drop.
6 7/ 8
Straight hitch ball mount
H
G
C
A
D
E
Hitch ball mount with 2” drop
F
(Hitch ball mount not included)
2“
ASSEMBLY
