91.27
3
1. The
ground clearance of ATV / UTV must be a minimum of 9"
,If not the addition of a lift kit is required.
2. The ATV / UTV
must be equipped with a 2” receiver hitch
. (See page 12, step 1 and 2 ) Application list page 29 & 30 .
3. The ATV / UTV
must be equipped with a winch with brake and steel cable
.( winches fitted with
nylon rope are not recommended
)
4. If the distance between the center of the hitch ball and the front of the ATV / UTV is more than 144 ", the addition of the frame extension (165-12021) is
required.
If the vehicle is equipped with tracks, see details on page 13 step 3.
Important details for the proper functioning of the mounting kit.
Selecting the hitch ball mount required for your ATV / UTV (
hitch ball mount not included
). (See page 12, step 1 and 2 ).
You must ensure that once the coupling hook is mounted to the hook mount and the hitch ball mount, that the bottom of the coupling hook is as close as
possible to the ground without affecting the operation of the suspension.
Bottom of the coupling hook as close as possible to the ground
The frame extends up to a maximum 144"
The ground clearance must be of at least 9"
IMPORTANT NOTICE BEFORE INSTALLATION
Important points to check before the installation of the universal Mounting Kit Q-Lock.
The Q-Lock universal mounting kit was designed to allow the installation of the Quadrax Plows on most
ATV / UTV equipped with an independent
rear suspension only
.
To make sure that the mounting kit can be installed on your ATV / UTV, please read and carefully follow the instructions and guidelines below.
Some vehicles may require suspension aids to maintain adequate ground clearance when the plow is raised
.
List of important things to check.
7"
6" 7/8
