4
12.
“
SWING
”
button
Press this button, the horizontal wind direction vanes can
swing automatically, when you have the desired vertical
wind direction, press it again, the horizontal wind direction
vanes will be stopped at the situation of your choice.
13.
“
DUST
”
button
This button is invalid.
14.
“
FUNGUSPROOF
”
button
This A/C has special dry and anti-mold function which
has
yes
two selections. This function is
“
”
or
“
no
”
controlled by the remote controller under cooling, dry and
auto (cooling and dry) modes, the horizontal wind guiding
bars are at the initial position for cooling. The A/C runs
under heating mode(the cooling only A/C only runs under
fan mode), the internal fan runs for three minutes with weak
wind before stop. The purpose of this function is to dry the
inside of the evaporator and to prevent the evaporator from
going mouldy due to water deposition and thus dispersing
strange smell.
Note:
1. This function has not been set in the factory. You may
freely set and cancel this function. The setting method
is: under
off
status of the A/C and the remote
“
”
controller, point the remote controller toward the A/C
and continuously press
pushbutton
“
FUNGUSPROOF
”
for one time, the buzzer keep beeping five times again
after five times beep, indicating that this function is
ready. In case this function has been set, unless the
whole A/C is powered off or the function is manually
cancelled, the A/C then has this function as default;
2. To cancel the function: 1. Power off the whole A/C; 2.
Under
off
status of the A/C and the remote
“
”
controller, point the remote controller toward the A/C
and continuously press
pushbutton
“
FUNGUSPROOF
”
for one time, the buzzer keep beeping three times again
after five times beep, indicating that this function has
been cancelled;
3. When this function is on, it is suggested not to restart
the A/C before it is completely stop;
4. This function will not run in case of time stop or sleep
stop.
