COLOR PURITY ADJUSTMENT AND CONVERGENCE ADJUSTMENT
COLOR PURITY ADJUSTMENT
1.
Before color purity adjustment, Warm up the TV set over 15 minutes and fully degauss.
2.
Receive pure white signal in AV status and set the TV receiver dynamic.
3.
Go to factory mode "MENU2". After write down the values of R-BIAS and B-BIAS, set the values of
R-BIAS and B-BIAS zero.
4.
Loosen the clamp screw of the deflection yoke and pull the deflection yoke towards color purity
magnetic loop.
5.
Adjust color purity magnetic loop to make the green area at the center of CRT screen,
6.
Slowly push the deflection yoke toward the front of CRT and set it where a uniform green field is
obtained. Tighten the clamp screw of the deflection yoke.
7.
Restore the values of R-BIAS, G-BIAS and B-BIAS.
CONVERGENCE ADJUSTMENT
8.
Receive a dotted pattern. Set the TV receiver dynamic.
9.
Loose the convergence magnet clamper and align red with blue dots at the center of the screen by
rotating (R, B) static convergence magnets.
10.
Align Red/Blue with green dots at the center of the screen by rotating (RB-G) static convergence
magnet.
11.
Remove the DY wedges and slightly tilt the deflection yoke horizontally and vertically to obtain the
good overall convergence, Fix them after the good overall convergence got.
12.
Fix the convergence magnets by turning the clamper.
13.
If purity error Is found, follow "PURITY ADJUSTMENT" instructions.
Summary of Contents for CTV-37V10
Page 8: ......