Quadro Manual I: Installation Guide
Step 2: Configuring the Quadro
Quadro2x, 2xi, Quadro4x, 4xi, 4xa, Quadro16x, 16xi; (SW Version 4.1.x)
38
DDI
(Device Dialing Inward) service and
TEI mode
can be selected from the first page of
the ISDN Wizard.
Fig. I-36: ISDN Wizard – Page 1
Leave
DDI Service
disabled if you wish to use MSN services (i.e. if you have more than
one ISDN number provided by the Central Office). Configure
TEI mode
according to ISDN
provider requirements.
Clicking
Next
will refer to the ISDN Wizard page where MSN Settings can be configured.
Fig. I-37: ISDN Wizard – Page 2
If you left
DDI Service
disabled, this page will offer you the choice of using MSN services
or not.
If you have one ISDN number assigned to the corresponding ISDN trunk, select the
No
other devices are connected to ISDN bus
radio button and define the destination where
to route the incoming calls.
If you have more than one ISDN numbers provided by the Central Office, select the
Other
devices are connected to ISDN bus
radio button. This selection will require you to config-
ure the MSN Table after finishing the ISDN Wizard. The MSN table can be accessed from
the table on the
ISDN Trunk Settings
page, by pressing the
MSN Service
link for the cor-
responding trunk.
Summary of Contents for Quadro2x
Page 1: ......
