Quadro6L/4L/2x2 Manual I: Installation Guide
Step 2: Configuring the Quadro
Quadro6L/4L/2x2; (SW Version 5.3.x and higher)
33
Click on the IP Line number to enter the
IP Lines Settings
page.
Fig. l- 33: IP Line Settings page
Select the
SIP Phone
radio button. Select the SIP IP phone model from the
Phone Model
drop-down list.
Please Note:
If your IP phone is not listed in the
Phone Model
drop-down list, select the
Other
option from the list to configure the SIP phone manually. The SIP phone’s configura-
tion is different dependent on the SIP phone model. For more information about SIP Phone
configuration, refer to the SIP phone manual or user’s guide.
Insert the SIP Phone’s
MAC address
in the corresponding fields. The MAC address of an
IP phone is usually printed on the back of the phone’s base unit.
In the
Line Appearances
text box, enter the number for simultaneous calls supported by
the SIP IP phone – which is the sum of the number of active and held calls. For example, if
this field is set to
1
, only one active call is possible to have on the phone and making or ac-
cepting a second call while the other is on hold will not be allowed. Note, that this number
depends on the phone brand and model, and cannot exceed the number of simultaneous
calls supported by the phone.
Username
and
Password
are required to be inserted for this selection. They should match
on both Quadro and SIP phone for a successful connection. The
Password
field is
checked against its strength and you may see how strong is your inserted password right
below that field. To achieve the well protected strong password minimum 8 characters of
letters in upper and lower case, symbols and numbers should be used. If you are unable to
define a strong password, press
Choose Generated Password
to use one of system de-
fined strong passwords.
Summary of Contents for Quadro2x2
Page 1: ......
