QuadroE1/T1 Manual I: Installation Guide
Configuring the Quadro E1/T1
QuadroE1/T1; (SW Version 3.2.x)
35
Attention:
When Quadro acts in the Network mode with the Attendant as a destination to
route the incoming calls, digit forwarding should be disabled on the PBX side. Otherwise,
incoming digits may be mistaken as special calling codes on the Quadro’s Attendant.
Cut Through checkbox is available when signaling selected from the Signaling Type drop
down list on the CAS Signaling Wizard – Page 2 is different from R2 (all types) and is used
to reconnect the call (terminated by some reason, e.g. user error, network problems, etc.) by
going on-hook and off-hook again even if the call partner is off-hook and not involved in the
call.
Automat Ringing Down checkbox is available when signaling selected from the Signaling
Type drop down list on the CAS Signaling Wizard – Page 2 is different from R2 (all types)
and allows an E1/T1 device connected to the Quadro to establish a hot-line call (automatic
call without any digits dialed).
Pass Through Pound Sign (#) checkbox is only available when signaling selected from the
Signaling Type drop down list on the CAS Signaling Wizard – Page 2 is different from
E&M FGD or R2 (except for R2-DTMF). When this checkbox is selected, the pound sign (#)
detected in the dialed number will be passed through and will be considered as a part of the
dialed number. When this checkbox is not selected, the detected pound sign (#) will be con-
sidered as a call acceleration digit.
Press Next to move to the forth page of the CAS Signaling Wizard:
Fig. I-31: CAS Signaling Wizard - page 4
This page only appears in E1 User mode when signaling selected from Signaling Type drop
down list on the CAS Signaling Wizard – Page 2 is R2 (all types) and is used to configure
country settings.
Country drop down list is used to set the location where Quadro is located to support the
correct functionality of R2 signaling. For countries absent in this list, use ITU selection.
Use Default Country Settings checkbox restores default advanced settings for the selected
country. When this checkbox is not selected, next page will provide a possibility to manually
configure advanced country settings.
Press Next to move to the fifth page of the CAS Signaling Wizard:
Summary of Contents for QuadroE1/T1
Page 1: ......
