QuadroE1/T1 Manual I: Installation Guide
Configuring the Quadro E1/T1
QuadroE1/T1; (SW Version 3.2.x)
40
Fig. I-36: Local Call Routing Wizard: Routing Call Type Add Entry page 1
Pattern requires the routing pattern. To make the specified call, the appropriate Call Code
should be dialed prior to the routing pattern. Only digit values and wildcard symbols are al-
lowed here:
•
the "?" character stands for only one unknown digit
•
the "*" character stands for any number of any digits.
•
'[' , ']' , ',' and '-' are used to define a range or a quantity of numbers, e.g. 8546033[0-2]
means that the dialed number may be 8546033-0. -1 or -2 to match the specified pat-
tern; for 2[3,7], the dialed number may be 23 or 27 to match the specified pattern.
Number of Discarded Symbols (NDS) specifies the number of digits that that should be
discarded from the beginning of the routing pattern. In this example, no digits have to be dis-
carded, so leave that field empty.
Prefix specifies digits that will be inserted at the beginning of the routing pattern. Leave the
field empty if no digits need to be added.
Suffix specifies digits that will be inserted at the end of the routing pattern. Leave the field
empty if no digits need to be added.
Call Type gives a possibility to select the routing call type (PBX, SIP, H.323, IP-PSTN or
E1/T1). For this example SIP has to be selected.
Metric allows entry of a rating for the selected route in a range from 0 to 20. If no value is in-
serted into this field, 10 will be used as a default. When two route entries match a user's dial
string, the route with the lower metric will be preferred. In this example the Metric field will
be left empty.
Summary of Contents for QuadroE1/T1
Page 1: ......