QuadroM32x Manual I: Installation Guide
Step 2: Configuring the Quadro
From this page, the destination for incoming calls to be routed to can be selected and other
routing settings might be configured.
Route Incoming Call to drop down appears when Both incoming and outgoing calls or
Incoming calls only is selected from the Allowed Call Type list and allows selecting the
destination where incoming calls should be routed. The list contains all extensions of the
Quadro, Attendant and Routing agent. Choosing the Routing with inbound destination
number selection will automatically use the initially dialed number to connect the destina-
tion without any additional dialing.
When DID service is enabled (in User mode only), incoming calls can be only routed to the
Routing agent with simple Routing and Routing with inbound destination number call
routing possibilities.
Attention:
When Quadro acts in the Network mode with the Attendant as a destination to
route the incoming calls, digit forwarding should be disabled on the PBX side. Otherwise,
incoming digits may be mistaken as special calling codes on the Quadro’s Attendant.
Cut Through checkbox is available when signaling selected from the Signaling Type drop
down list on the CAS Signaling Wizard – Page 2 is different from R2 (all types) and is
used to reconnect the call (terminated by some reason, e.g. user error, network problems,
etc.) by going on-hook and off-hook again even if the call partner is off-hook and not in-
volved in the call.
Automat Ringing Down checkbox is available when signaling selected from the Signaling
Type drop down list on the CAS Signaling Wizard – Page 2 is different from R2 (all types)
and allows an E1/T1 device connected to the Quadro to establish a hot-line call (automatic
call without any digits dialed).
Pass Through Pound Sign (#) checkbox is only available when signaling selected from
the Signaling Type drop down list on the CAS Signaling Wizard – Page 2 is different
from E&M FGD or R2 (except for R2-DTMF). When this checkbox is selected, the pound
sign (#) detected in the dialed number will be passed through and will be considered as a
part of the dialed number. When this checkbox is not selected, the detected pound sign (#)
will be considered as a call acceleration digit.
Press Next to move to the forth page of the CAS Signaling Wizard:
Fig. I-36: CAS Signaling Wizard - page 4
This page only appears in E1 User mode when signaling selected from Signaling Type
drop down list on the CAS Signaling Wizard – Page 2 is R2 (all types) and is used to con-
figure country settings.
QuadroM32x; (SW Version 5.2.x)
39
Summary of Contents for QuadroM32x
Page 1: ......
