Step 13 Plug in the Cat5 cable from the DTM into the base station. On powering up the base station,
the speaker in the post will beep four times. This is the system carrying out checks to ensure that the
speaker and mic are connected properly and operational. The LED will flash amber and then turn
constant RED when ready and on standby. If the LED is flashing red or amber, see ‘Trouble shooting’
on page 22.
Step 14 Now register the headsets to the base station. Take
the charged batteries and insert one into each headset.
The headsets will pulse white initially then red when not
registered. Hold the headset to the base station as shown.
The LED on the end of the boom will fast-flash green during
the registration process, then double pulse green when
registered. Repeat this process one at a time until each
headset is registered.
Step 15 To test the audio link to the order
point, have someone go out to the order
point. Press vehicle detection override
on the base station. The speaker in the
order point is live. Press ‘I’ on the headset
to talk with the person at the order point.
When you’ve spoken and heard the person
outside, the test is done. Press vehicle
detection override again to de-activate it.
page 7
Pin Colour Connection
1
White Chime Sve
2
Red
Chime Speaker -ve
3
Blue
Timer out Common
4
Green Timer out NO
5
Brown Timer greet +ve
6
Grey
Timer greet -ve
7
Purple Ext. Activation Common
8
Yellow Ext. Activation Detect
Power
Connection to
timer & grill
speaker
Connection to
table service
if used
Cat5 cable
from DTM
Connection to
repeater
if used
Figure 8 - Connecting to base station (top)
Figure 9 - Registering the headset
Vehicle detection override
Figure 10 - Testing the audio link
